Campbell_Science_Fair_Display

Campbell School Science Fair Display Ideas:

Science fair presenters will be standing BEHIND their projects, NOT in front of their projects. (This keeps the aisles clear for our science fair visitors!)
If you are planning to use a science fair display board, please be sure to lower the height of your science fair board OR create a LARGE open space in the middle section of the display board so that you can easily stand behind it!! (Please refer to the pictures above and below for display ideas!)
Chairs, step-stools, and ladders are not permitted in the science fair. (They are a fire & safety hazard!)
Due to very limited space, ALL projects must be displayed on the tables. Plan on approximately 3 feet of table space. The dimensions of the science fair tables are listed on the bottom of this page.
Due to the large number of projects presented, wall space or floor space will NOT be allowed to display any parts of projects.

HOW LARGE A SPACE??
- If you're planning on creating a space in the middle of your display board, PLEASE make that the space is as LARGE as possible!! Otherwise, you will not be very comfortable standing behind your project for the entire science fair.
- My recommendation for creating a space in the middle is to follow the dimensions using the picture below:

HOW ABOUT LOWERING THE DISPLAY BOARD??
- If you're planning on LOWERING the height your display board, PLEASE make that the middle part of the board is space is low enough!! I would not make the middle section any higher than 10 inches. Otherwise, you will not be very comfortable standing behind your project for the entire science fair, especially if you have parts of your project that you need to reach that are displayed on the table!
- My recommendation for lowering the display board is to follow the dimensions using the picture below:
HERE'S A THIRD IDEA:
- If you're planning on LOWERING the height your display board, you could also simply turn the display board on its side and use one of the side flaps as the back display area.
- I would recommend removing the other side flap and use parts of that cardboard to fashion two triangles to be taped on to the back display area. Creating a cardboard frame, as pictured below, supports the back flap so that it stands up straight.

Science fair participants will be presenting their projects using the tables that are in the all-purpose room.
These are the same tables that students normally use during lunchtime.
These tables are 28 1/2 inches high and are 26 inches deep (see picture below):